Does the back of your electric shower resemble this ?


So your old shower has been tiled around rather than behind - someone has used a block connector to extend the wires ?

New replacement showers require a flat surface to fix to - otherwise your warranty is void ! The reason being that when the unit is fixed to an un-even wall the unit will flex and twist this may bind the switches making them stick in the on or off position or the casing will not fit correctly. 



Before - Quite often we come across this scenario where the shower has been tiled around the outside.  Manufacturers look for this so they can renege on their warranty FACT !  We have a solution that avoids having to fill in the hole left by the previous shower.


 



We always replace any block connectors with a purpose made crimps and insulation sleeves.




After - So I tidy up the wiring and fit a new acrylic panel which covers the imprint of the previous shower.

The new panel supplied and fitted from £49 (300 x 500mm seen below) and £69 for the 400 x 600mm panel - but only when already fitting a new shower. This works out far cheaper than employing a tradesman to make good the tiles - wiring - plumbing.



These panels are a solid 5mm thick giving a rigid base to support your new shower they are very striking. Choose a colour to co-ordinate or to contrast your tile scheme.


Choose your colour

 We have red and white in stock 300 x 500 mm & 400 x 600 mm - With or without visible chrome screw fixings. Other colours and sizes 2 weeks notice. Panel above is gloss red 433 size is 300 x 500 mm.


300 x 500 mm panel supplied and fitted with a new  Triton T80Easi 8.5 kw shower £298

400 x 600 mm panel supplied and fitted with a new  Triton T80Easi 8.5 kw shower £318

300 x 500 mm panel supplied and fitted with a new Mira Sprint 8.5 kw shower £308

400 x 600 mm panel supplied and fitted with a new Mira Sprint 8.5 kw shower £328